Project: Black Wolf Glider
This is not a true Glider, more of a controlled faller
like the Shuttlecraft is !
 |
 |
|
Above picture is missing the side mount body tubes nosecones RockSim just don't like adding them, sounds like a good addition to me. |
|
|
|
uses (1) 54mm main motor & (4) 29mm RF remote motors Landing pad/rail on bottom |
 |
| 54mm motor mount, fin seat within the long space between center rings. |
 |
| Fin passes thru outer motor tube.
Servo's mount within the tube for rear rudder control. |
 |
| Dual 29mm motor mounts installed ( 29/240 case max. ) each side. |
 |
| Shows the servo mounted with the side tube for rudder control. |
 |
| The RF receiver is mounted in the left side
tube and battery in the right.
The center ejection area has the pass thru wiring metal tape covered and epoxy add on top of that. The ejection charge drops inside the motor tube and is controlled via the RF receiver and tripped by a servo, but the parachute is only for backup |
 |
| Ray Dunakin "Argosy" nose cone, Very
Cool, Thanks Ray!! It has been
foam filled and ready for the cap and eyelet |
 |
| Temp fitting for that need to see it fix!! |
 |
| The first Coat of primer in place, also the
rear Rudders are now installed.
There will be around 5 coats of paint total,( two primer, three finish coats) Still looking for some good nose cones for the 2 outboard tubes. |
 |
| Main body Painted and ready for the install of
the Electronics and control arms. All
Electronics will be mount inside the 2 outside airframes nosecones, RF receiver in one side and batteries in the other for balance. |
More to come, as I complete this project, should be done around July
Hey any questions or comments?
